#
# BT Factory Settings Information File
# ====================================
#
# All Factory settings information must be stored as follows
#
# Philips:
# <CHIP_ID> <HCI_revision> <LMP_Subversion> <FactorysettingsFile_HEAD_xx)>
#
# there CHIP_ID, HCI_revision and LMP_Subversion are read from firmware at start-up.
#
# ST: <CHIP_ID> is set to 0x00000000 since this is not used by ST.
#
# ====================================
# STLC2500_R4_02_05.ssf                                 static settings file for STLC2590 and 2500C4 (minikit)
# STLC2592_R5_01_02_UART.ssf                            static settings file for STLC2592   (minikit)
# STLC2593_R5_02_01_UART.ssf                            static settings file for STLC2593 D2 (minikit)
# STLC2593_R5_03_05_SEMC_SPI_unified_Lisbon.ssf         static settings file for STLC2593 D3, Lisbon enabled
# STLC2594_R5_04_01_E3_SEMC_SPI_unified_9ms.ssf         static settings file for STLC2593 D4
# STLC2500_R6_00_01_SPI_SEMC_Maxipard.ssf               static settings file for STLC2690 cut 1 (used in Maxipard)
# ----------------------------------------------------------------------------------------
# 
0x00000000	0x0402	0x0520	STLC2500_R4_02_05.ssf
0x00000000	0x0501	0x00EF	STLC2592_R5_01_02_UART.ssf
0x00000000	0x0502	0x00F0	STLC2593_R5_02_01_UART.ssf
0x00000000	0x0503	0x00F1	STLC2593_R5_03_05_SEMC_SPI_unified_Lisbon.ssf
0x00000000	0x0504	0x00F2	STLC2594_R5_04_01_E3_SEMC_SPI_unified_9ms.ssf
0x00000000	0x0600	0x0001	STLC2500_R6_00_01_SPI_SEMC_Maxipard.ssf

